Hardware Datasheets

• ASL ASLH483 (Emlite EMA1.ay) Single Phase Meter: ASLH483 Multi-Utility Meter Data Sheet.pdf
• Emlite Polyphase (3 Phase) CT or Whole Current Meter: Polyphase Meter EMP1 WC or CT.pdf

Hardware Manuals

• Elster / Honewell 3 Phase A1140 Meter: A1140-complete-manual.pdf

Replacing Modems

If we supply you with a replacement modem, for example to upgrade from 2G to 4G comms, please follow the procedure below:

• Ensure the meter is fully turned off before replacing the modem.
• For Emlite meters, the modem is situated at the top of top of the meter and can be removed by loosening the screw(s) holding it in place.
• For Elster A1140 meters, the modem is situated under the bottom cover, which is held in place by two screws, left and right.

• Please record the following information:

• Serial number of the modem, which can be found on the rear of the modem.

• Serial number of the meter that you are fitting the modem on to.

Please provide the information above to the staff at support@juggle.energy who will be able to update the records in Juggle.

Installing New ASL Meters

The basic meter installation is as for any energy meter - the range of meters are straightforward electrically and any competent electrician will be able to complete the installation.

If Juggle Energy have provided you with the meter (with a modem and SIM included) then you only need to provide the following information to Juggle Energy Ltd to allow this to be set up:

• If this is a replacement meter, the existing "emig ID" of the meter.
• The serial number of the meter (we will hold records of the modem & SIM details)
• The "name" of the site / property and the full postal address
• For PV systems, the maximum AC power rating of the connected inverter(s)

Obtaining a good Mobile Signal

Please see:

Successfully installing an antenna